The Big Green 7 Gets Seafoamed

As A member of the forums on bimmerforums.com, theres been alot of talk about this seafoam thing and after hearing basically nothing but good results ive decided to try it. For about 2 days i did my research before doing any thing, being that i didnt want to do anything wrong or mess anything up. My Advice is you do yours too.

The First thing i did was get all of my tools/supplies together.
What you need?
1 -3 8oz cups
2 -A Funnel
3 -A 10" Socket
4 -a hose whose opening is 1/4
5 -your can of seafoam

Next Pop the hood and remove the engine cover, it is held in place by 4 10mm nuts (not you dont have to turn them all the way
whats attached to these nuts are basically attached to hooks that which if you turn them to hard they will break off the cover so gently turn them untill they come loose)
After that youll see your engine.
Pic1:


The Next thing to do is look towards the back part of the engine on your right hand top side (facing the engine)
for a sort of nozzle of port, heres a pic so you dont get confused, The Pic is kind of fuzzy, but theres a arrow pointing on the nozzle that your looking for


Heres a picture of the peice you were suppose to remove. Make sure you dont pull it off with pliers because if you do then you might put a hole in it


Once you find your nozzle take your hose and slide it on, it should slide right on, but if it doesnt dont panic, just make sure its pushed as far on as possible.
Heres a pic with the hose attached


The next thing to do is seperate the seafoam equally what i did was use 3 plastic cups and evened it out in all 3 ( i didnt have 3 cups one blew away so i used 2 cups emptied one in the bowl and then fill it up again, this made it even. heres a pic of that:


The bottle says to put 1/3 in the oil, 1/3 in the gas, and 1/3 in the air intake. All i did was put 1/3 in the oil heres a pic of that


Then i Turned on the car, They say you should have someone rev up the car up to about 2,000rpm. i didnt have anyone to do it with so i actually did it kind of ghetto, and used a stick to hold the pedal ( this is not advised) this was achieved by squeezing the stick between the seat and the pedal. (After putting down the e-brake.

After doing this then you want to slowly let the hose suck up the seafoam from the cup


take your time though because you dont want the car to stall. when it is almost done just let is suck up the rest of it, then immediately shut it off let the engine sit for 20mins, after 20 mins passed then start the car and enjoy the smoke show!